No.	Question	A	B	C	D	Answer
37	A weld fillet gage measures	A. the face of the weld	B. the throat of the weld	C. the toe of the weld	D. depth of fusion	A B C D
38	Undercutting is a condition that generally occurs when the	A. welding current is too high	B. welding current is too low	C. welding travel speed is too slow	D. arc length is too short	A B C D
39	During the guided bend test, when the face of the weld is on the outside of the "U", it is likely the examiner is looking for	A. cross-sectional strength	B. quality off fusion	C. shearing strength	D. degree of penetration	A B C D
40	A guided bend test specimen for mild steel is bent at an angle of _______ degrees.	A. 45	B. 60	C. 180	D. 270	A B C D
41	Refer to the picture below when answering questions 41 - 44 Identify part A	A. face	B. toe	C. root	D. leg	A B C D
42	Identify part B	A. toe	B. reinforcement	C. face	D. leg	A B C D
43	Identify part C	A. Penetration	B. face	C. toe	D. leg	A B C D
44	Identify part D	A. toe	B. fusion zone	C. face	D. leg	A B C D
45	Which of the following weld test methods would be most useful in detecting internal defects	A. dye penetrant	B. visual	C. ultrasonic	D. magnetic particle	A B C D
46	Which of the following characteristics of a weld could not be determined by visual inspection	A. cracks	B. dilution	C. inclusions	D. contour	A B C D